Restyle, replace, or fill any part of a track — without leaving the session.
Drop in audio. Cover the whole thing, replace a marked section, or infill a gap — right in your DAW. Every result renders against the source tempo and key and lands as a 24-bit WAV you drag onto the timeline. No bouncing, no round-trips.
Three modes
One tab, three jobs
Cover
Restyle the whole file while the source melody and structure carry through.
Acoustic guitar demo → lo-fi hip-hop version.
Replace
Mark a section with the trim handles, then re-render only that range.
Mark verse 2, prompt a new instrument, replace.
Infill
Fill an empty gap between two existing parts of the same track.
Fill a 4-bar gap between verse and chorus.
Waveform trim handles
Drag two handles on the waveform to mark the target section. Replace and Infill only render inside those bounds — audio outside the selection stays untouched, and the result drops back as a 24-bit WAV on your timeline.
- Drag handles to define start and end
- BPM and key read from source
- Crossfades on edited regions
- 24-bit WAV, ready to drag in
Common edits
Real workflows
- Extend a short loop into a longer arrangement draft
- Replace a verse that doesn't fit the track
- Change instrumentation for a single marked section
- Turn a piano demo into a full-band version
- Patch a gap after cutting a weak bar
- Render a guitar idea as a synth-led version
Try Transform in your DAW.
100 trial credits on signup. No card required.